TI SN65HVD233MDREP
1/1 Transceiver Half CANbus 8-SOIC
Brands: ti
Mfr.Part #: SN65HVD233MDREP
Datasheet: SN65HVD233MDREP Datasheet (PDF)
Package/Case: SOIC (D)-8
RoHS Status:
Stock Condition: 7174 pcs, New Original
Warranty: 1 Year Ovaga Warranty - Find Out More
0
1
Add To BomSN65HVD233MDREP General Description
The SN65HVD233 is used in applications employing the controller area network (CAN) serial communication physical layer in accordance with the ISO 11898 standard. As a CAN transceiver, it provides transmit and receive capability between the differential CAN bus and a CAN controller, with signaling rates up to 1 Mbps.
Designed for operation in especially harsh environments, the device features cross-wire, overvoltage and loss of ground protection to ±36 V, with overtemperature protection and common-mode transient protection of ±100 V. This device operates over a 7-V to 12-V common-mode range with a maximum of 60 nodes on a bus.
If the common-mode range is restricted to the ISO-11898 Standard range of 2 V to 7 V, up to 120 nodes may be connected on a bus. This transceiver interfaces the single-ended CAN controller with the differential CAN bus found in industrial, building automation, and automotive applications.
The RS (pin 8) of the SN65HVD233 provides for three modes of operation: high-speed, slope control, or low-power standby mode. The high-speed mode of operation is selected by connecting RS directly to ground, allowing the driver output transistors to switch on and off as fast as possible with no limitation on the rise and fall slope. The rise and fall slope can be adjusted by connecting a resistor to ground at RS, since the slope is proportional to the pin's output current. Slope control is implemented with a resistor value of 10 k to achieve a slew rate of 15 V/µs and a value of 100 k to achieve 2.0 V/µs slew rate. For more information about slope control, refer to the application information section.
The SN65HVD233 enters a low-current standby mode during which the driver is switched off and the receiver remains active if a high logic level is applied to RS. The local protocol controller reverses this low-current standby mode when it needs to transmit to the bus.
A logic high on the loopback LBK (pin 5) of the SN65HVD233 places the bus output and bus input in a high-impedance state. The remaining circuit remains active and available for driver to receiver loopback, self-diagnostic node functions without disturbing the bus.
Features
- Bus-Pin Fault Protection Exceeds ±36 V
- Bus-Pin ESD Protection Exceeds 16-kV HBM
- Compatible With ISO 11898
- Signaling Rates(1) up to 1 Mbps
- Extended –7-V to 12-V Common-Mode Range
- High-Input Impedance Allows for 120 Nodes
- LVTTL I/Os Are 5-V Tolerant
- Adjustable Driver Transition Times for Improved Signal Quality
- Unpowered Node Does Not Disturb the Bus
- Low-Current Standby Mode . . . 200-µA Typical
- Thermal Shutdown Protection
- Power-Up/Down Glitch-Free Bus Inputs and Outputs
- High Input Impedance With Low VCC
- Monolithic Output During Power Cycling
- Loopback for Diagnostic Functions Available
- DeviceNet Vendor ID #806(1)
- SUPPORTS DEFENSE, AEROSPACE, AND MEDICAL APPLICATIONS
- Controlled Baseline
- One Assembly/Test Site
- One Fabrication Site
- Available in Military (–55°C/125°C) Temperature Range(1)
- Extended Product Life Cycle
- Extended Product-Change Notification
- Product Traceability
- APPLICATIONS
- CAN Data Bus
- Industrial Automation
- DeviceNet Data Buses
- Smart Distributed Systems (SDS™)
- SAE J1939 Standard Data Bus Interface
- NMEA 2000 Standard Data Bus Interface
- ISO 11783 Standard Data Bus Interface
(1) The signaling rate of a line is the number of voltage transitions that are made per second expressed in the units bps (bits per second).
(1) Additional temperature ranges available - contact factory
DeviceNet is a trademark of Open DeviceNet Vendor Association.
Specifications
Parameter | Value | Parameter | Value |
---|---|---|---|
Protocols | CAN | Number of channels | 1 |
Supply voltage (V) | 3 to 3.6 | Bus fault voltage (V) | -36 to 36 |
Signaling rate (max) (MBits) | 1 | Rating | HiRel Enhanced Product |
Operating temperature range (°C) | -55 to 125 | Low-power mode | Silent |
Common-mode voltage (V) | -7 to 12 |
Shipping
Shipping Type | Ship Fee | Lead Time | |
---|---|---|---|
DHL | $20.00-$40.00 (0.50 KG) | 2-5 days | |
Fedex | $20.00-$40.00 (0.50 KG) | 2-5 days | |
UPS | $20.00-$40.00 (0.50 KG) | 2-5 days | |
TNT | $20.00-$40.00 (0.50 KG) | 2-5 days | |
EMS | $20.00-$40.00 (0.50 KG) | 2-5 days | |
REGISTERED AIR MAIL | $20.00-$40.00 (0.50 KG) | 2-5 days |
Processing Time:Shipping fee depend on different zone and country.
Payment
Terms of payment | Hand Fee | |
---|---|---|
Wire Transfer | charge US$30.00 banking fee. | |
Paypal | charge 4.0% service fee. | |
Credit Card | charge 3.5% service fee. | |
Western Union | charge US.00 banking fee. | |
Money Gram | charge US$0.00 banking fee. |
Guarantees
1.The electronic components you purchase include 365 Days Warranty, We guarantee product quality.
2.If some of the items you received aren't of perfect quality, we would resiponsibly arrange your refund or replacement. But the items must remain their orginal condition.
Packing
-
Step1 :Product
-
Step2 :Vacuum packaging
-
Step3 :Anti-static bag
-
Step4 :Individual packaging
-
Step5 :Packaging boxes
-
Step6 :bar-code shipping tag
All the products will packing in anti-staticbag. Ship with ESD antistatic protection.
Outside ESD packing’s lable will use ourcompany’s information: Part Mumber, Brand and Quantity.
We will inspect all the goods before shipment,ensure all the products at good condition and ensure the parts are new originalmatch datasheet.
After all the goods are ensure no problems afterpacking, we will packing safely and send by global express. It exhibitsexcellent puncture and tear resistance along with good seal integrity.
We provide high quality products, thoughtful service and after sale guarantee
-
We have rich products, can meet your various needs.
-
Minimum order quantity starts from 1pcs.
-
Lowest international shipping fee starts from $0.00
-
365 days quality guarantee for all products