This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

WINBOND W83977AF

PLUG & PLAY1.0ACOMPLIANT

ISO14001 ISO9001 DUNS

Brands: WINBOND

Mfr.Part #: W83977AF

Datasheet: W83977AF Datasheet (PDF)

Package/Case: QFP128

RoHS Status:

Stock Condition: 6554 pcs, New Original

Warranty: 1 Year Ovaga Warranty - Find Out More

Add To Bom

Quick Quote

Please submit RFQ for W83977AF or email to us: Email: [email protected], we will contact you within 12 hours.

W83977AF General Description

GENERAL DESCRIPTIONThis data sheet covers two products: W83977F, and W83977AF whose pin assignment, and most of the functions are the same. W83977AF is an advanced version of W83977F featuring the FIR function.FEATURESGeneral• Plug & Play 1.0A Compliant• Support 13 IRQs, 4 DMA channels, full 16-bit addresses decoding• Capable of ISA Bus IRQ Sharing• Compliant with Microsoft PC97 Hardware Design Guide• Support DPM (Device Power Management), ACPI• Programmable configuration settings• 24 or 14.318 Mhz clock inputFDC• Compatible with IBM PC AT disk drive systems• Variable write pre-compensation with track selectable capability• Support vertical recording format• DMA enable logic• 16-byte data FIFOs• Support floppy disk drives and tape drives• Detects all overrun and underrun conditions• Built-in address mark detection circuit to simplify the read electronics• FDD anti-virus functions with software write protect and FDD write enable signal (write data signal was forced to be inactive)• Support up to four 3.5-inch or 5.25-inch floppy disk drives• Completely compatible with industry standard 82077• 360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps data transfer rate• Support 3-mode FDD, and its Win95 driverUART• Two high-speed 16550 compatible UARTs with 16-byte send/receive FIFOs• 3rd UART with 32-byte send/receive FIFO is supported for IR function [W83977AF only]• MIDI compatible• Fully programmable serial-interface characteristics:   --- 5, 6, 7 or 8-bit characters   --- Even, odd or no parity bit generation/detection   --- 1, 1.5 or 2 stop bits generation• Internal diagnostic capabilities:   --- Loop-back controls for communications link fault isolation   --- Break, parity, overrun, framing error simulation• Programmable baud generator allows division of 1.8461 Mhz and 24 Mhz by 1 to (216-1)• Maximum baud rate up to 921k bps for 14.769 Mhz and 1.5M bps for 24 MhzInfrared• Support IrDA version 1.0 SIR protocol with maximum baud rate up to 115.2K bps• Support SHARP ASK-IR protocol with maximum baud rate up to 57,600 bps• Support IrDA version 1.1 MIR (1.152M bps) and FIR (4M bps) protocol [W83977AF only]   --- Single DMA channel for transmitter or receiver   --- 3rd UART with 32-byte FIFO is supported in both TX/RX transmission [W83977AF only]   --- 8-byte status FIFO is supported to store received frame status (such as overrun CRC error, etc.)• Support auto-config SIR and FIR [W83977AF only]Parallel Port• Compatible with IBM parallel port• Support PS/2 compatible bi-directional parallel port• Support Enhanced Parallel Port (EPP) - Compatible with IEEE 1284 specification• Support Extended Capabilities Port (ECP) - Compatible with IEEE 1284 specification• Extension FDD mode supports disk drive B; and Extension 2FDD mode supports disk drives A and B through parallel port• Enhanced printer port back-drive current protectionAdvanced Power Management (APM) Controlling• Power turned on when RTC reaches a preset date and time• Power turned on when a ring pulse or pulse train is detected on the PHRI, or when a high to low transition on PWAKIN1, or PWAKIN2 input signals• Power turned on when PANSW input signal indicates a switch on event• Power turned off when PANSW input signal indicates a switch off event• Power turned off when a fail-safe event occurs (power-save mode detected but system is hung up)• Power turned off when software issues a power off commandKeyboard Controller• 8042 based with optional F/W from AMIKKEYTM-2, Phoenix MultiKey/42TM or customer code with 2K bytes of programmable ROM, and 256 bytes of RAM• Asynchronous Access to Two Data Registers and One status Register• Software compatibility with the 8042 and PC87911 microcontrollers• Support PS/2 mouse• Support port 92• Support both interrupt and polling modes• Fast Gate A20 and Hardware Keyboard Reset• 8 Bit Timer/ Counter; support binary and BCD arithmetic• 6, 8, 12, or 16 Mhz operating frequency (16 Mhz available only if input clock rate = 14.318 Mhz)

Features

  • General
  • Plug & Play 1.0A Compliant
  • Support 13 IRQs, 4 DMA channels, full 16-bit addresses decoding
  • Capable of ISA Bus IRQ Sharing
  • Compliant with Microsoft PC97 Hardware Design Guide
  • Support DPM (Device Power Management), ACPI
  • Programmable configuration settings
  • 24 or 14.318 Mhz clock input
WINBOND Inventory

Shipping

Shipping Type Ship Fee Lead Time
DHL DHL $20.00-$40.00 (0.50 KG) 2-5 days
Fedex Fedex $20.00-$40.00 (0.50 KG) 2-5 days
UPS UPS $20.00-$40.00 (0.50 KG) 2-5 days
TNT TNT $20.00-$40.00 (0.50 KG) 2-5 days
EMS EMS $20.00-$40.00 (0.50 KG) 2-5 days
REGISTERED AIR MAIL REGISTERED AIR MAIL $20.00-$40.00 (0.50 KG) 2-5 days

Processing Time:Shipping fee depend on different zone and country.

Payment

Terms of payment Hand Fee
Wire Transfer Wire Transfer charge US$30.00 banking fee.
Paypal Paypal charge 4.0% service fee.
Credit Card Credit Card charge 3.5% service fee.
Western Union Western Union charge US.00 banking fee.
Money Gram Money Gram charge US$0.00 banking fee.

Guarantees

1.The electronic components you purchase include 365 Days Warranty, We guarantee product quality.

2.If some of the items you received aren't of perfect quality, we would resiponsibly arrange your refund or replacement. But the items must remain their orginal condition.

Packing

  • Product

    Step1 :Product

  • Vacuum packaging

    Step2 :Vacuum packaging

  • Anti-static bag

    Step3 :Anti-static bag

  • Individual packaging

    Step4 :Individual packaging

  • Packaging boxes

    Step5 :Packaging boxes

  • bar-code shipping tag

    Step6 :bar-code shipping tag

All the products will packing in anti-staticbag. Ship with ESD antistatic protection.

Outside ESD packing’s lable will use ourcompany’s information: Part Mumber, Brand and Quantity.

We will inspect all the goods before shipment,ensure all the products at good condition and ensure the parts are new originalmatch datasheet.

After all the goods are ensure no problems afterpacking, we will packing safely and send by global express. It exhibitsexcellent puncture and tear resistance along with good seal integrity.

  • ESD
  • ESD

We provide high quality products, thoughtful service and after sale guarantee

  • Product

    We have rich products, can meet your various needs.

  • quantity

    Minimum order quantity starts from 1pcs.

  • shipping

    Lowest international shipping fee starts from $0.00

  • guarantee

    365 days quality guarantee for all products

Ratings and Reviews

Ratings
Please rate the product !
Please enter a comment

Please submit comments after logging into your account.

Submit